
AirflowBaby 2mm Mesh Crib Liner for Full-Size Slatted Cribs, 9-inch Panels, Gray
2mm weave
4.1 (5,210)$34.95

Fits: Slatted ends · Solid ends. Along the slats. Classic weave, 3mm, holding back 85% of the daylight.
$44.95
Listed by our retail partner, who sets it and can change it.
Our retail partner takes the order, ships it and handles returns under their own terms. Who brings the parcel · If it does not fit the crib
Setting up the crib begins with weaving these mesh panels through the slats. The two pieces wrap along the interior perimeter, covering three sides or four depending on the crib build. Bound fabric edges keep the mesh flat and tidy against the wooden frame.
This solid light pink adds a gentle wash of color across the crib interior. It pairs easily with white or natural wood slats, keeping the finished crib bright when daylight fills the room.
The bottom edge of the panel slides down between the slats and the mattress edge. It rests flat against the wood beneath the top of the mattress, keeping the mesh smooth and taut all the way around.
Our Classic mesh uses an open weave that lets light and air pass freely across the slats. The single-layer polyester fabric stays light, resisting sagging once pulled into position around the corners.
Wide hook and loop closures join the panels at the corners and along the rails. The straps wrap around the exterior slats, gripping firmly so the panels stay aligned after regular machine washing.
| Section | Crib Liners |
|---|---|
| Where it goes | Along the slats |
| Crib sides it is cut for | Slatted ends · Solid ends |
| Colorway | Light Pink |
| Mesh | Classic weave, 3mm |
| Daylight held back | 85% |
| Tested to | ASTM F1917 |
| Air permeability method | ASTM D737 |
| Ratings behind it | 26,859 at 4.5 out of 5 |
The panels are tested to the ASTM standard for infant bedding and related accessories.
The mesh is measured by the textile industry method for how readily air passes through a fabric.
When Congress banned padded crib bumpers, the definition CPSC wrote does not include a non-padded mesh crib liner. Our panels sit outside that ban.
The mesh liners have never been recalled. One product was, in 2013: a wearable blanket we stopped making that year.
The American Academy of Pediatrics recommends a bare crib: a firm flat mattress, a fitted sheet, and nothing else in it. That recommendation does not carve out mesh liners. Federal law and pediatric guidance say different things here, and we would rather you read both than hear only the half that suits us.
Keep it tight against the crib side. Do not use it if it hangs loose or sags toward the mattress. Position the ties on the outside of the crib and pull them snug. Never put pillows or anything else in the crib alongside it. Never use it in a toddler bed or bassinet.
Take the panel out of the crib once your baby can pull up to standing against the crib side, which starts at around six months. An older baby can use it to climb.
It is cut for slatted ends · solid ends. If you are not sure which yours is, will it fit my crib walks the crib side with you and shows only the pieces that fit it.
It is our Classic weave at 3mm, which holds back 85% of the daylight. The other weaves in the catalog are AirflowBaby at 2mm and 60%, Deluxe at 4mm and 80%.
No. It is a non-padded mesh panel. The Safe Sleep for Babies Act was signed in May 2022, and the ban on padded crib bumpers took effect that November. It reaches padded bumpers, vinyl guards and vertical slat covers. The definition CPSC wrote for it does not include a non-padded mesh crib liner.
The same piece is listed in 10 colorways: Light Pink, White, Best Friends, Gray, Gray Chevron, Safari Fun Too, Safari Fun Girl, Peaceful Elephants, Starlight, Lavender.

2mm weave
4.1 (5,210)$34.95

3mm weave
4.5 (4,723)$39.95

4mm weave
4.5 (795)$59.95

4mm weave
4.5 (795)$59.95
$44.95