Breathable Mesh Liner for Mini Cribs, Classic 3mm Mesh (Covers 4 Sides), White

4.5 (4,723)

Fits: Mini and portable. Along the slats. Classic weave, 3mm, holding back 85% of the daylight.

$39.95

Listed by our retail partner, who sets it and can change it.

Our retail partner takes the order, ships it and handles returns under their own terms. Who brings the parcel · If it does not fit the crib

Around the interior slats of a mini crib, this single panel wraps all four sides in our Classic mesh weave. The cloth sits flat against the upright spindles and pulls smooth across each corner post. We finish the fabric with matching top and bottom binding to keep the shape taut along the rails.

Choosing plain white

White mesh matches natural wood, painted rails, or dark finishes without drawing the eye away from the crib itself. The solid color looks crisp across the nursery and pairs easily with any sheet pattern on the mattress.

Setting the lower edge

The bottom edge drops below the top of the mattress so the mesh lies flat along the lower rail. When you pull the fabric taut, the cloth stays flush against the wooden slats rather than bunching along the corners.

Fastening to the posts

Ties along the top edge loop around the corner posts and exterior slats, while hook and loop closures hold the panel end to end. The fasteners grip firmly so the mesh panel remains upright and smooth.

Finishing the borders

Fabric binding covers the raw mesh along the top and bottom edges. The double-stitched trim stiffens the long panel, keeping the line straight from one side of the crib to the next after cycles in the wash.

What is measured

Section	Crib Liners
Where it goes	Along the slats
Crib sides it is cut for	Mini and portable
Colorway	White
Mesh	Classic weave, 3mm
Daylight held back	85%
Tested to	ASTM F1917
Air permeability method	ASTM D737
Ratings behind it	4,723 at 4.5 out of 5

Standards, and what the law covers

Tested to ASTM F1917

The panels are tested to the ASTM standard for infant bedding and related accessories.

Air permeability under ASTM D737

The mesh is measured by the textile industry method for how readily air passes through a fabric.

Not a crib bumper under federal law

When Congress banned padded crib bumpers, the definition CPSC wrote does not include a non-padded mesh crib liner. Our panels sit outside that ban.

No recall of the mesh panels

The mesh liners have never been recalled. One product was, in 2013: a wearable blanket we stopped making that year.

What the guidance says, in full

The American Academy of Pediatrics recommends a bare crib: a firm flat mattress, a fitted sheet, and nothing else in it. That recommendation does not carve out mesh liners. Federal law and pediatric guidance say different things here, and we would rather you read both than hear only the half that suits us.

Fitting it, in order

Face the side with the larger holes into the crib, so the finer surface sits outward.
Run the panel along the inside of the rails and wrap the last slat at each end.
Point the ties upward and fasten them on the outside of the frame, never inside.
Set the bottom edge about an inch below the top of the mattress, then pull every tie snug.

Keep it tight against the crib side. Do not use it if it hangs loose or sags toward the mattress. Position the ties on the outside of the crib and pull them snug. Never put pillows or anything else in the crib alongside it. Never use it in a toddler bed or bassinet.

When to take it out

Take the panel out of the crib once your baby can pull up to standing against the crib side, which starts at around six months. An older baby can use it to climb.

Asked about this one

Will it fit my crib?

It is cut for mini and portable. If you are not sure which yours is, will it fit my crib walks the crib side with you and shows only the pieces that fit it.

How open is this weave?

It is our Classic weave at 3mm, which holds back 85% of the daylight. The other weaves in the catalog are AirflowBaby at 2mm and 60%, Deluxe at 4mm and 80%.

Is this a padded bumper?

No. It is a non-padded mesh panel. The Safe Sleep for Babies Act was signed in May 2022, and the ban on padded crib bumpers took effect that November. It reaches padded bumpers, vinyl guards and vertical slat covers. The definition CPSC wrote for it does not include a non-padded mesh crib liner.