Breathable Mesh RailGuard Teething Cover, 27" Short Panels (2-Pack), Light Pink

4.6 (87)

Fits: Slatted ends · Solid ends. Over the top rail. Classic weave, 3mm, holding back 85% of the daylight.

$29.95

Listed by our retail partner, who sets it and can change it.

Our retail partner takes the order, ships it and handles returns under their own terms. Who brings the parcel · If it does not fit the crib

Across the nursery, the pale blush color sits quietly along the top edge of the crib. We make this pair of short panels to wrap the side rails, using our Classic weave bound in smooth polyester trim. Adjustable straps and hook and loop fasteners close the fabric neatly over slatted or solid wood ends.

Light pink colorway

The pale blush tone sits softly against white paint or natural wood finishes. It reads as a quiet, warm neutral across the room, keeping the focus on the lines of the crib rather than loud contrast.

Classic mesh weave

We use a single layer of our Classic weave across each panel. The knit stays open across the surface of the rail, letting daylight through while covering the bare wood from end to end.

Strap and rail fastening

Hook and loop strips run the length of the fabric to wrap over the top rail. Adjustable straps loop down to hold each short panel flat against cribs with open slats or solid end boards.

Machine wash care

Toss the panels in the washing machine when they need cleaning. Fasten the hook and loop tabs together before washing so the rough edges do not catch on the mesh or pull the binding.

What is measured

Section	Rail & Teething Covers
Where it goes	Over the top rail
Crib sides it is cut for	Slatted ends · Solid ends
Colorway	Light Pink
Mesh	Classic weave, 3mm
Daylight held back	85%
Tested to	ASTM F1917
Air permeability method	ASTM D737
Ratings behind it	87 at 4.6 out of 5

Standards, and what the law covers

Tested to ASTM F1917

The panels are tested to the ASTM standard for infant bedding and related accessories.

Air permeability under ASTM D737

The mesh is measured by the textile industry method for how readily air passes through a fabric.

Not a crib bumper under federal law

When Congress banned padded crib bumpers, the definition CPSC wrote does not include a non-padded mesh crib liner. Our panels sit outside that ban.

No recall of the mesh panels

The mesh liners have never been recalled. One product was, in 2013: a wearable blanket we stopped making that year.

What the guidance says, in full

The American Academy of Pediatrics recommends a bare crib: a firm flat mattress, a fitted sheet, and nothing else in it. That recommendation does not carve out mesh liners. Federal law and pediatric guidance say different things here, and we would rather you read both than hear only the half that suits us.

Fitting it, in order

Face the side with the larger holes into the crib, so the finer surface sits outward.
Run the panel along the inside of the rails and wrap the last slat at each end.
Point the ties upward and fasten them on the outside of the frame, never inside.
Set the bottom edge about an inch below the top of the mattress, then pull every tie snug.

Keep it tight against the crib side. Do not use it if it hangs loose or sags toward the mattress. Position the ties on the outside of the crib and pull them snug. Never put pillows or anything else in the crib alongside it. Never use it in a toddler bed or bassinet.

When to take it out

Take the panel out of the crib once your baby can pull up to standing against the crib side, which starts at around six months. An older baby can use it to climb.

Asked about this one

Will it fit my crib?

It is cut for slatted ends · solid ends. If you are not sure which yours is, will it fit my crib walks the crib side with you and shows only the pieces that fit it.

How open is this weave?

It is our Classic weave at 3mm, which holds back 85% of the daylight. The other weaves in the catalog are AirflowBaby at 2mm and 60%, Deluxe at 4mm and 80%.

Is this a padded bumper?

No. It is a non-padded mesh panel. The Safe Sleep for Babies Act was signed in May 2022, and the ban on padded crib bumpers took effect that November. It reaches padded bumpers, vinyl guards and vertical slat covers. The definition CPSC wrote for it does not include a non-padded mesh crib liner.