Straight to the page
BreathableBabyWill it fit my crib
Breathable Mesh Liner for Full-Size Cribs, Classic 3mm Mesh (Covers 3 or 4 Sides), Gray Clover

Breathable Mesh Liner for Full-Size Cribs, Classic 3mm Mesh (Covers 3 or 4 Sides), Gray Clover

4.5 (26,956)

Fits: Slatted ends · Solid ends. Along the slats. Classic weave, 3mm, holding back 85% of the daylight.

$41.95

Read from the listing, which can change it at any time.

The order is taken, packed and sent from the listing the button opens, under the terms shown there. Who brings the parcel · If it does not fit the crib

Setting up the crib begins with wrapping the slats. We weave our Classic mesh as an open fabric with bound fabric trim along both horizontal edges. This set gives you two panels to fit around the interior sides, finished in a quiet Gray Clover print that sits easily with light wood or white paint.

Two panel construction

You get one long panel and one short panel in the box. Use both to cover all four sides of a slatted crib, or run the long panel alone across three sides when one end is solid wood.

Fastening across the slats

Wide hook and loop strips close each panel around the corner posts and outer slats. Fabric ties anchor the upper edge so the cloth stays upright and taut between the rails without sagging over time.

Gray Clover print

The clover pattern repeats in a quiet gray across the white ground. It reads as a soft neutral from the doorway and shows its geometric leaf shapes up close beside the mattress.

Tucking the lower edge

Push the bottom trim down between the mattress and the crib slats. The panel pulls flat against the inner face of the rails, resting below the top line of the mattress for a tidy, flush fit.

What is measured

SectionCrib Liners
Where it goesAlong the slats
Crib sides it is cut forSlatted ends · Solid ends
ColorwayGray Clover
MeshClassic weave, 3mm
Daylight held back85%
Tested toASTM F1917
Air permeability methodASTM D737
Ratings behind it26,956 at 4.5 out of 5

Standards, and what the law covers

Tested to ASTM F1917

The panels are tested to the ASTM standard for infant bedding and related accessories.

Air permeability under ASTM D737

The mesh is measured by the textile industry method for how readily air passes through a fabric.

Not a crib bumper under federal law

When Congress banned padded crib bumpers, the definition CPSC wrote does not include a non-padded mesh crib liner. Our panels sit outside that ban.

No recall of the mesh panels

The mesh liners have never been recalled. One product was, in 2013: a wearable blanket we stopped making that year.

What the guidance says, in full

The American Academy of Pediatrics recommends a bare crib: a firm flat mattress, a fitted sheet, and nothing else in it. That recommendation does not carve out mesh liners. Federal law and pediatric guidance say different things here, and we would rather you read both than hear only the half that suits us.

Fitting it, in order

  1. Face the side with the larger holes into the crib, so the finer surface sits outward.
  2. Run the panel along the inside of the rails and wrap the last slat at each end.
  3. Point the ties upward and fasten them on the outside of the frame, never inside.
  4. Set the bottom edge about an inch below the top of the mattress, then pull every tie snug.

Keep it tight against the crib side. Do not use it if it hangs loose or sags toward the mattress. Position the ties on the outside of the crib and pull them snug. Never put pillows or anything else in the crib alongside it. Never use it in a toddler bed or bassinet.

When to take it out

Take the panel out of the crib once your baby can pull up to standing against the crib side, which starts at around six months. An older baby can use it to climb.

Asked about this one

Will it fit my crib?

It is cut for slatted ends · solid ends. If you are not sure which yours is, will it fit my crib walks the crib side with you and shows only the pieces that fit it.

How open is this weave?

It is our Classic weave at 3mm, which holds back 85% of the daylight. The other weaves in the catalog are AirflowBaby at 2mm and 60%, Deluxe at 4mm and 80%.

Is this a padded bumper?

No. It is a non-padded mesh panel. The Safe Sleep for Babies Act was signed in May 2022, and the ban on padded crib bumpers took effect that November. It reaches padded bumpers, vinyl guards and vertical slat covers. The definition CPSC wrote for it does not include a non-padded mesh crib liner.

What else does it come in?

The same piece is listed in 10 colorways: Gray Clover, White, Light Pink, Best Friends, Gray, Safari Fun Too, Safari Fun Girl, Peaceful Elephants, Starlight, Lavender.

Breathable Mesh Liner for Full-Size Cribs, Classic 3mm Mesh (Covers 3 or 4 Sides), Gray Clover

$41.95