
AirflowBaby 2mm Mesh Crib Liner for Full-Size Slatted Cribs, 9-inch Panels, Gray
2mm weave
4.1 (5,210)$34.95

Fits: Slatted ends · Solid ends. Along the slats. Classic weave, 3mm, holding back 85% of the daylight.
$44.95
Listed by our retail partner, who sets it and can change it.
Our retail partner takes the order, ships it and handles returns under their own terms. Who brings the parcel · If it does not fit the crib
Along the interior slats of a standard crib, these mesh panels form a neat perimeter between the rails and the mattress top. We weave our Classic mesh to hang flat against the wood, threading past corner posts and securing in place. The muted gray colorway fits quietly alongside painted or natural wood frames.
We use our Classic mesh for this panel, working with an open polyester weave that allows room air to pass through the fabric. Daylight reaches into the crib through the grid of threads.
Hook and loop closures wrap around the corner posts and outer slats to pull each panel taut. Use both panels for slatted cribs, or mount only the long panel when dressing three sides.
A solid fabric binding runs along the top and bottom edges of the mesh. The lower trim tucks down below the top of the mattress, keeping the hem resting flat along the crib base.
This solid gray reads as a soft, neutral tone from across the room. The solid dyed yarn holds its color through regular cycles in the washing machine without fading against white crib rails.
| Section | Crib Liners |
|---|---|
| Where it goes | Along the slats |
| Crib sides it is cut for | Slatted ends · Solid ends |
| Colorway | Gray |
| Mesh | Classic weave, 3mm |
| Daylight held back | 85% |
| Tested to | ASTM F1917 |
| Air permeability method | ASTM D737 |
| Ratings behind it | 26,859 at 4.5 out of 5 |
The panels are tested to the ASTM standard for infant bedding and related accessories.
The mesh is measured by the textile industry method for how readily air passes through a fabric.
When Congress banned padded crib bumpers, the definition CPSC wrote does not include a non-padded mesh crib liner. Our panels sit outside that ban.
The mesh liners have never been recalled. One product was, in 2013: a wearable blanket we stopped making that year.
The American Academy of Pediatrics recommends a bare crib: a firm flat mattress, a fitted sheet, and nothing else in it. That recommendation does not carve out mesh liners. Federal law and pediatric guidance say different things here, and we would rather you read both than hear only the half that suits us.
Keep it tight against the crib side. Do not use it if it hangs loose or sags toward the mattress. Position the ties on the outside of the crib and pull them snug. Never put pillows or anything else in the crib alongside it. Never use it in a toddler bed or bassinet.
Take the panel out of the crib once your baby can pull up to standing against the crib side, which starts at around six months. An older baby can use it to climb.
It is cut for slatted ends · solid ends. If you are not sure which yours is, will it fit my crib walks the crib side with you and shows only the pieces that fit it.
It is our Classic weave at 3mm, which holds back 85% of the daylight. The other weaves in the catalog are AirflowBaby at 2mm and 60%, Deluxe at 4mm and 80%.
No. It is a non-padded mesh panel. The Safe Sleep for Babies Act was signed in May 2022, and the ban on padded crib bumpers took effect that November. It reaches padded bumpers, vinyl guards and vertical slat covers. The definition CPSC wrote for it does not include a non-padded mesh crib liner.
The same piece is listed in 10 colorways: Gray, White, Light Pink, Best Friends, Gray Chevron, Safari Fun Too, Safari Fun Girl, Peaceful Elephants, Starlight, Lavender.

2mm weave
4.1 (5,210)$34.95

3mm weave
4.5 (4,723)$39.95

4mm weave
4.5 (795)$59.95

4mm weave
4.5 (795)$59.95
$44.95