
AirflowBaby 2mm Mesh Crib Liner for Full-Size Slatted Cribs, 9-inch Panels, Gray
2mm weave
4.1 (5,210)$34.95

Fits: Slatted ends · Solid ends. Along the slats. Classic weave, 3mm, holding back 85% of the daylight.
$44.95
Listed by our retail partner, who sets it and can change it.
Our retail partner takes the order, ships it and handles returns under their own terms. Who brings the parcel · If it does not fit the crib
The classic mesh feels light and smooth between your fingers, with enough body to hold its form along the wood. We weave this polyester cloth with an open grid that lets daylight into the crib. Two panels wrap the slats, finished along the top and bottom with matching solid trim.
We make this panel from our classic polyester mesh. The yarn forms an open grid across the surface. It stays taut between the slats and keeps its shape after months on the frame.
Push the bottom edge down between the mattress and the slatted sides. The trim sits below the top of the mattress, pulling the mesh flat against the vertical rails so the panels stay neat.
The solid lavender fabric reads soft and clear from across the nursery. We dye the mesh and the matching edge trim to the same tone, giving the slatted rails a quiet, finished look.
Close the hook and loop fasteners before placing the panels in the washing machine. The polyester fabric dries quickly and goes straight back onto the crib rails without losing its tension.
| Section | Crib Liners |
|---|---|
| Where it goes | Along the slats |
| Crib sides it is cut for | Slatted ends · Solid ends |
| Colorway | Lavender |
| Mesh | Classic weave, 3mm |
| Daylight held back | 85% |
| Tested to | ASTM F1917 |
| Air permeability method | ASTM D737 |
| Ratings behind it | 26,859 at 4.5 out of 5 |
The panels are tested to the ASTM standard for infant bedding and related accessories.
The mesh is measured by the textile industry method for how readily air passes through a fabric.
When Congress banned padded crib bumpers, the definition CPSC wrote does not include a non-padded mesh crib liner. Our panels sit outside that ban.
The mesh liners have never been recalled. One product was, in 2013: a wearable blanket we stopped making that year.
The American Academy of Pediatrics recommends a bare crib: a firm flat mattress, a fitted sheet, and nothing else in it. That recommendation does not carve out mesh liners. Federal law and pediatric guidance say different things here, and we would rather you read both than hear only the half that suits us.
Keep it tight against the crib side. Do not use it if it hangs loose or sags toward the mattress. Position the ties on the outside of the crib and pull them snug. Never put pillows or anything else in the crib alongside it. Never use it in a toddler bed or bassinet.
Take the panel out of the crib once your baby can pull up to standing against the crib side, which starts at around six months. An older baby can use it to climb.
It is cut for slatted ends · solid ends. If you are not sure which yours is, will it fit my crib walks the crib side with you and shows only the pieces that fit it.
It is our Classic weave at 3mm, which holds back 85% of the daylight. The other weaves in the catalog are AirflowBaby at 2mm and 60%, Deluxe at 4mm and 80%.
No. It is a non-padded mesh panel. The Safe Sleep for Babies Act was signed in May 2022, and the ban on padded crib bumpers took effect that November. It reaches padded bumpers, vinyl guards and vertical slat covers. The definition CPSC wrote for it does not include a non-padded mesh crib liner.
The same piece is listed in 10 colorways: Lavender, White, Light Pink, Best Friends, Gray, Gray Chevron, Safari Fun Too, Safari Fun Girl, Peaceful Elephants, Starlight.

2mm weave
4.1 (5,210)$34.95

3mm weave
4.5 (4,723)$39.95

4mm weave
4.5 (795)$59.95

4mm weave
4.5 (795)$59.95
$44.95