Straight to the page
BreathableBabyWill it fit my crib
Breathable Mesh RailGuard Teething Cover, 51" Long Panel, Gray

Breathable Mesh RailGuard Teething Cover, 51" Long Panel, Gray

4.6 (352)

Fits: Slatted ends · Solid ends. Over the top rail. Classic weave, 3mm, holding back 85% of the daylight.

$24.95

Listed by our retail partner, who sets it and can change it.

Our retail partner takes the order, ships it and handles returns under their own terms. Who brings the parcel · If it does not fit the crib

Wrap this single long panel over the wide top rail as soon as the crib is set up. The polyester mesh folds over the wood and stays in place with hook and loop fasteners and adjustable straps, fitting cribs with slatted sides or solid end boards.

Top rail wrap

The panel folds over the upper edge of the wood, bringing the Classic mesh down both sides of the crib rail. Hook and loop sections and adjustable straps pull the cloth taut against slatted sides and solid ends.

Outer mesh pocket

A small pocket sits on the exterior face of the panel, pointing into the room rather than toward the mattress. It holds teething rings and pacifiers within reach along the front of the crib.

Gray colorway

The solid gray fabric reads as a quiet neutral against white, natural, or dark stained wood. It matches our solid crib liners and sheets or pairs with patterned bedding across the room.

Machine wash routine

Fasten the hook and loop tabs together before putting the panel in the washing machine. The all-polyester weave washes clean and dries quickly on the line, ready to wrap back over the rail.

What is measured

SectionRail & Teething Covers
Where it goesOver the top rail
Crib sides it is cut forSlatted ends · Solid ends
ColorwayGray
MeshClassic weave, 3mm
Daylight held back85%
Tested toASTM F1917
Air permeability methodASTM D737
Ratings behind it352 at 4.6 out of 5

Standards, and what the law covers

Tested to ASTM F1917

The panels are tested to the ASTM standard for infant bedding and related accessories.

Air permeability under ASTM D737

The mesh is measured by the textile industry method for how readily air passes through a fabric.

Not a crib bumper under federal law

When Congress banned padded crib bumpers, the definition CPSC wrote does not include a non-padded mesh crib liner. Our panels sit outside that ban.

No recall of the mesh panels

The mesh liners have never been recalled. One product was, in 2013: a wearable blanket we stopped making that year.

What the guidance says, in full

The American Academy of Pediatrics recommends a bare crib: a firm flat mattress, a fitted sheet, and nothing else in it. That recommendation does not carve out mesh liners. Federal law and pediatric guidance say different things here, and we would rather you read both than hear only the half that suits us.

Fitting it, in order

  1. Face the side with the larger holes into the crib, so the finer surface sits outward.
  2. Run the panel along the inside of the rails and wrap the last slat at each end.
  3. Point the ties upward and fasten them on the outside of the frame, never inside.
  4. Set the bottom edge about an inch below the top of the mattress, then pull every tie snug.

Keep it tight against the crib side. Do not use it if it hangs loose or sags toward the mattress. Position the ties on the outside of the crib and pull them snug. Never put pillows or anything else in the crib alongside it. Never use it in a toddler bed or bassinet.

When to take it out

Take the panel out of the crib once your baby can pull up to standing against the crib side, which starts at around six months. An older baby can use it to climb.

Asked about this one

Will it fit my crib?

It is cut for slatted ends · solid ends. If you are not sure which yours is, will it fit my crib walks the crib side with you and shows only the pieces that fit it.

How open is this weave?

It is our Classic weave at 3mm, which holds back 85% of the daylight. The other weaves in the catalog are AirflowBaby at 2mm and 60%, Deluxe at 4mm and 80%.

Is this a padded bumper?

No. It is a non-padded mesh panel. The Safe Sleep for Babies Act was signed in May 2022, and the ban on padded crib bumpers took effect that November. It reaches padded bumpers, vinyl guards and vertical slat covers. The definition CPSC wrote for it does not include a non-padded mesh crib liner.

What else does it come in?

The same piece is listed in 2 colorways: Gray, White.

The same piece, other colorways

Others in Rail & Teething Covers

Breathable Mesh RailGuard Teething Cover, 51" Long Panel, Gray

$24.95