Breathable Mesh Liner for Mini Cribs, Deluxe 4mm Mesh (Covers 4 Sides), Sand Beach

4.6 (16)

Fits: Mini and portable. Along the slats. Deluxe weave, 4mm, holding back 80% of the daylight.

$54.95

Read from the listing, which can change it at any time.

The order is taken, packed and sent from the listing the button opens, under the terms shown there. Who brings the parcel · If it does not fit the crib

Setting up a mini crib means working with a smaller frame where every corner post counts. We weave this single long panel from our Deluxe mesh to wrap around all four interior sides. The fabric sits taut against the slats, held in place with clean fasteners so the sides remain neat.

Fastening along the slats

Ties and hook and loop closures line the panel edge to anchor the cloth to the corner posts and outer slats. You thread the fasteners through the woodwork and press them flat so the fabric stays upright and taut.

Binding the long edges

Solid fabric trim binds the top and bottom borders of the Deluxe mesh. The stitched edge gives the panel clean lines across the crib sides and keeps the open weave lying flat without curling along the mattress line.

Reading the Sand Beach tone

Sand Beach is a warm, neutral shade that blends quiet tan with soft off-white. The subtle tone pairs easily with natural wood crib finishes or painted nursery furniture without overwhelming the surrounding room.

Washing and resetting the panel

The polyester mesh panel goes directly into the washing machine when needed. It dries quickly on the line or rack, ready to thread through the mini crib corners and tie back onto the frame without losing its rectangular shape.

What is measured

Section	Crib Liners
Where it goes	Along the slats
Crib sides it is cut for	Mini and portable
Colorway	Sand Beach
Mesh	Deluxe weave, 4mm
Daylight held back	80%
Tested to	ASTM F1917
Air permeability method	ASTM D737
Ratings behind it	16 at 4.6 out of 5

Standards, and what the law covers

Tested to ASTM F1917

The panels are tested to the ASTM standard for infant bedding and related accessories.

Air permeability under ASTM D737

The mesh is measured by the textile industry method for how readily air passes through a fabric.

Not a crib bumper under federal law

When Congress banned padded crib bumpers, the definition CPSC wrote does not include a non-padded mesh crib liner. Our panels sit outside that ban.

No recall of the mesh panels

The mesh liners have never been recalled. One product was, in 2013: a wearable blanket we stopped making that year.

What the guidance says, in full

The American Academy of Pediatrics recommends a bare crib: a firm flat mattress, a fitted sheet, and nothing else in it. That recommendation does not carve out mesh liners. Federal law and pediatric guidance say different things here, and we would rather you read both than hear only the half that suits us.

Fitting it, in order

Face the side with the larger holes into the crib, so the finer surface sits outward.
Run the panel along the inside of the rails and wrap the last slat at each end.
Point the ties upward and fasten them on the outside of the frame, never inside.
Set the bottom edge about an inch below the top of the mattress, then pull every tie snug.

Keep it tight against the crib side. Do not use it if it hangs loose or sags toward the mattress. Position the ties on the outside of the crib and pull them snug. Never put pillows or anything else in the crib alongside it. Never use it in a toddler bed or bassinet.

When to take it out

Take the panel out of the crib once your baby can pull up to standing against the crib side, which starts at around six months. An older baby can use it to climb.

Asked about this one

Will it fit my crib?

It is cut for mini and portable. If you are not sure which yours is, will it fit my crib walks the crib side with you and shows only the pieces that fit it.

How open is this weave?

It is our Deluxe weave at 4mm, which holds back 80% of the daylight. The other weaves in the catalog are AirflowBaby at 2mm and 60%, Classic at 3mm and 85%.

Is this a padded bumper?

No. It is a non-padded mesh panel. The Safe Sleep for Babies Act was signed in May 2022, and the ban on padded crib bumpers took effect that November. It reaches padded bumpers, vinyl guards and vertical slat covers. The definition CPSC wrote for it does not include a non-padded mesh crib liner.