
Breathable Mesh Liner for Full-Size Cribs, Classic 3mm Mesh (Covers 3 or 4 Sides), Gray Clover
3mm weave
4.5 (26,956)$41.95

Fits: Solid ends. Along the slats. Classic weave, 3mm, holding back 85% of the daylight.
$42.95
Read from the listing, which can change it at any time.
The order is taken, packed and sent from the listing the button opens, under the terms shown there. Who brings the parcel · If it does not fit the crib
Across the room, the gray panels settle into the wood rails with a muted, uniform finish. We weave our Classic mesh to hang taut along the open slats, leaving the solid headboard and footboard bare. Two matching lengths cover the long crib sides.
Fastening strips attach directly around the outer crib slats to hold each section flat. You pull the ends firmly and press the hook and loop closed, keeping the fabric tight without extra slack hanging down the wood posts.
The neutral gray cloth gives the interior sides an even tone that pairs with light painted cribs or natural wood finishes. The color remains uniform across the open weave and the bound edges.
Each panel drops down past the slats so you can tuck the lower fabric trim beneath the top edge of the mattress. This placement keeps the bottom border pinned flat between the bedding and the inner crib wall.
You can pull the panels off the slats and wash the polyester fabric in the washing machine. The weave dries quickly and goes right back onto the crib rails with the same corner fasteners.
| Section | Crib Liners |
|---|---|
| Where it goes | Along the slats |
| Crib sides it is cut for | Solid ends |
| Colorway | Gray |
| Mesh | Classic weave, 3mm |
| Daylight held back | 85% |
| Tested to | ASTM F1917 |
| Air permeability method | ASTM D737 |
| Ratings behind it | 431 at 4.4 out of 5 |
The panels are tested to the ASTM standard for infant bedding and related accessories.
The mesh is measured by the textile industry method for how readily air passes through a fabric.
When Congress banned padded crib bumpers, the definition CPSC wrote does not include a non-padded mesh crib liner. Our panels sit outside that ban.
The mesh liners have never been recalled. One product was, in 2013: a wearable blanket we stopped making that year.
The American Academy of Pediatrics recommends a bare crib: a firm flat mattress, a fitted sheet, and nothing else in it. That recommendation does not carve out mesh liners. Federal law and pediatric guidance say different things here, and we would rather you read both than hear only the half that suits us.
Keep it tight against the crib side. Do not use it if it hangs loose or sags toward the mattress. Position the ties on the outside of the crib and pull them snug. Never put pillows or anything else in the crib alongside it. Never use it in a toddler bed or bassinet.
Take the panel out of the crib once your baby can pull up to standing against the crib side, which starts at around six months. An older baby can use it to climb.
It is cut for solid ends. If you are not sure which yours is, will it fit my crib walks the crib side with you and shows only the pieces that fit it.
It is our Classic weave at 3mm, which holds back 85% of the daylight. The other weaves in the catalog are AirflowBaby at 2mm and 60%, Deluxe at 4mm and 80%.
No. It is a non-padded mesh panel. The Safe Sleep for Babies Act was signed in May 2022, and the ban on padded crib bumpers took effect that November. It reaches padded bumpers, vinyl guards and vertical slat covers. The definition CPSC wrote for it does not include a non-padded mesh crib liner.
The same piece is listed in 2 colorways: Gray, White.

3mm weave
4.5 (26,956)$41.95

2mm weave
4.1 (5,210)$34.95

3mm weave
4.5 (4,723)$39.95

4mm weave
4.5 (795)$59.95
$42.95